Description
Contents: 10 x industrial adhesive 5 g, 10 x granulate 10 g, 1 x free display
INSTRUCTIONS FOR THE HG ADHESIVE REPAIR SET
1. CLEANING THE SURFACES
The “Lasnaad uit de fles” (weld seam from the bottle) can only develop its full adhesive strength if the parts to be repaired are prepared accordingly. Ideally, the surface is roughened with sandpaper or a wire brush and all dirt is cleaned. There must be no dust, rust, grease or glue residues and the adhesive surfaces must be completely dry. Only then can high adhesion values be achieved.
2. SCATTER THE GRANULATE
Subsequently, the parts to be bonded are joined exactly at the breaking point and a fine layer of granulate is applied. The powder height must not exceed 2 mm. Before the industrial adhesive is added, no chemical reaction takes place.
3. APPLY INDUSTRIAL GLUE
Now the industrial adhesive HG-Extreme 1.0 of the second bottle is carefully dripped onto the granulate until all grains are saturated with glue. As soon as the two components come into contact with each other, a chemical reaction occurs and heat is generated. We always recommend to provide both sides of the break with a weld for maximum durability. The more often the glue process is repeated, the more stable the connection becomes.
4. CURE THE CONNECTION
After only a few seconds, the welded seam reaches its full adhesive power. When the chemical reaction is complete, the seam can be ground, drilled or painted immediately. Depending on the material, the final strength of the fracture may vary.
